Universidad de Burgos Repositorio Repositorio
Por favor, use este identificador para citar o enlazar este ítem: http://hdl.handle.net/10259/4652

Ver estadísticas de uso
Título : Learning CAD at university through summaries of the rules of design intent
Autor : Ramos Barbero, Basilio
Melgosa Pedrosa, Carlos
Zamora Samperio, Raúl
Publicado en: International journal of technology and design education. 2017, V. 27, n. 3, p. 481–498
Editorial : Springer
Fecha de publicación : sep-2017
Fecha de disponibilidad: sep-2018
ISSN : 0957-7572
DOI: 10.1007/s10798-016-9358-z
Resumen : The ease with which 3D CAD models may be modified and reused are two key aspects that improve the design-intent variable and that can significantly shorten the development timelines of a product. A set of rules are gathered from various authors that take different 3D modelling strategies into account. These rules are then applied to CAD strategic-knowledge learning methodology and included in 3D CAD modelling exercises for students following the degree in mechanical engineering at the University of Burgos (Spain). The experiment was conducted in two groups with a total of 75 students. The design-intent rules were introduced in the different exercises that the teacher explained in both the theoretical and the practical classes. In addition, a summary of the different design rules in each of the practical exercises was explained in the practical classes in only one of the groups. The experimental results, reported in this paper, tested the influence of these summaries on overall improvements in 3D modelling and on the design-intent variable, which is subdivided into four sections: skeleton, structures, alterations and constraints. The use of the summaries of the design intent rules led to statistically significant improvements in 3D modelling in the experimental group, in comparison with the group of students to whom those summaries were not explained.
Palabras clave: Strategic knowledge
3D CAD learning
Reuse and alteration of the CAD model
Design intent
3D design rules
Materia: Enseñanza superior
Education, Higher
URI : http://hdl.handle.net/10259/4652
Versión del editor: https://doi.org/10.1007/s10798-016-9358-z
Aparece en las colecciones: Artículos Área de Expresión Gráfica en la Ingeniería

Ficheros en este ítem:

Fichero Descripción Tamaño Formato
Ramos-IJTDE_2017.pdf454,52 kBAdobe PDFVisualizar/Abrir

Los ítems del Repositorio Institucional de la Universidad de Burgos están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.

 

Valid XHTML 1.0! DSpace Software Copyright © 2002-2008 MIT and Hewlett-Packard - Sobre DSpace