2026-04-29T20:37:45Zhttps://riubu.ubu.es/oai/request

oai:riubu.ubu.es:10259/80002023-11-14T01:05:32Zcom_10259_6171com_10259_5086com_10259_2604col_10259_6172

Santamaría, Amaia Revilla Cuesta, Víctor Skaf Revenga, Marta Romera, Jesús María 2023-11-13T11:28:45Z 2023-11-13T11:28:45Z 2023-07 2214-5095 http://hdl.handle.net/10259/8000 10.1016/j.cscm.2023.e02142 The construction industry in general is, through minor low-cost processing methods, converting several of its by-products into viable materials; furthermore, some siderurgic sector by-products are likewise of use. In this context, large-scale batches (mix volumes over 0.5 m3 ) of good quality structural concrete are proposed, in which two kinds of binder and two kinds of aggregate (steel slag and recycled concrete) are used to perform four concrete mixtures, containing more than 80 % in mass of good-quality recycled materials. A batch of tests, both in the fresh and in the hardened state, are performed, covering on-site placement and long-term properties, to guarantee the suitability and the quality of the mixtures as structural concretes. Most of the results were encouraging, mainly depending on the aggregate and the binder types that were used. The freshstate workability of all the test mixtures was good. All the results in terms of hardened properties, strength (42 MPa in type I cement mixtures, and 32–38 MPa in type III cement mixtures), stiffness, long-term shrinkage, and microstructural state (porosity, permeability) were acceptable, their quality depending on the type of each component. The good results of the mixtures based on the slag-based binder deserve attention. Some weak points found were the slightly higher specific weight of the slag aggregate mixes (amounting to more than 2.7 Mg/m3 ), plastic shrinkage rates (in some cases greater than 1.2–1.5 thousand), and loss of resistance against chlorine penetration in recycled concrete mixes. However, drawbacks of that sort are no obstacle to their use in most structural applications. The authors wish to express their gratitude to the following entities for the funding they provided: MCIN/AEI/10.13039/501100011033 and ERDF A way of making Europe, the European Union, and Next Generation EU/PRTR [PID2020-113837RB-I00; PID2021–124203OB-I00 and TED2021-129715B-I00]; the Junta de Castilla y León (Regional Government) and ERDF [UIC-231]; the Basque Government [IT1619-22 SAREN Research Group]; the University of Burgos [Y135. GI]. eng Elsevier Case Studies in Construction Materials. 2023, V. 18, e02142 https://doi.org/10.1016/j.cscm.2023.e02142 Attribution-NonCommercial-NoDerivatives 4.0 Internacional http://creativecommons.org/licenses/by-nc-nd/4.0/ info:eu-repo/semantics/openAccess Electric arc furnace slag Ground granulated black furnace slag Ladle furnace slag Quarry tailings Recycled concrete aggregate Sustainable concrete Fresh properties Shrinkage Water penetration Chloride penetration Ingeniería civil Materiales de construcción Civil engineering Building materials Full-scale sustainable structural concrete containing high proportions of by-products and waste info:eu-repo/semantics/article info:eu-repo/semantics/publishedVersion Case Studies in Construction Materials 18