Por favor, use este identificador para citar o enlazar este ítem: http://hdl.handle.net/10259/6890
Título
Revision of the Spanish quality control procedure for rofills and random fillings
Publicado en
R-Evolucionando el transporte
Editorial
Universidad de Burgos. Servicio de Publicaciones e Imagen Institucional
Fecha de publicación
2021-07
ISBN
978-84-18465-12-3
DOI
10.36443/10259/6890
Descripción
Trabajo presentado en: R-Evolucionando el transporte, XIV Congreso de Ingeniería del Transporte (CIT 2021), realizado en modalidad online los días 6, 7 y 8 de julio de 2021, organizado por la Universidad de Burgos
Abstract
Infrastructure quality control must be done through an adequate control process, which
must be well planned, programmed and executed. It implies the revision of the specific
control procedures as part of the general objective of continuous improvement. It must be
applied to the construction of quarries with stone materials, called rockfills for large sizes
or random fillings for intermediate products. There continues to be a problem in terms of
compacting control methods in the execution of these diggings, with little practical
development of new techniques when the spread is of good – quality material an aspect
that must be revised in order to ensure the quality of the final result extended and
compacted. The current procedures for Quality Control in rock compaction have limited
operability. For example, the granulometric analysis with macro-pits (4m3) it is have done
with heavy fractions, being a destructive testing. The average density control by nuclear
methods has high heterogeneity, low performance and low thickness tested. The
topographic measurement settlement is the most accurate, but it is a poorly referenced
method. For the wheel impression test, the required values do not impose any limitation.
This research studies the application use to granites, slates and granitic alteration soils
stabilized using cement. The necessary field and laboratory works were developed in order
to elaborate new test procedures for a proposed compaction control in rocks. The
compaction control procedures revised were wheel impression test, topographic settlement
and plate load test (PLT). Doing simple regression on SPSS, in which any predictor
outcome variable (dependent) should be placed (independent). An analysis of variance
ANOVA shows the sums of squares and the degrees of freedom associated with each: is
significant at p < 0,05. There is less than 0,5% chance that an F Levene – ratio this large
would happen if the null hypothesis were true.
Palabras clave
Infraestructuras
Infrastructures
Materia
Ingeniería civil
Civil engineering
Transportes
Transportation
Versión del editor
Relacionado con
Aparece en las colecciones