Afficher la notice abrégée

dc.contributor.authorSantamaría, Amaia
dc.contributor.authorRevilla Cuesta, Víctor 
dc.contributor.authorSkaf Revenga, Marta 
dc.contributor.authorRomera, Jesús María
dc.date.accessioned2023-11-13T11:28:45Z
dc.date.available2023-11-13T11:28:45Z
dc.date.issued2023-07
dc.identifier.issn2214-5095
dc.identifier.urihttp://hdl.handle.net/10259/8000
dc.description.abstractThe construction industry in general is, through minor low-cost processing methods, converting several of its by-products into viable materials; furthermore, some siderurgic sector by-products are likewise of use. In this context, large-scale batches (mix volumes over 0.5 m3 ) of good quality structural concrete are proposed, in which two kinds of binder and two kinds of aggregate (steel slag and recycled concrete) are used to perform four concrete mixtures, containing more than 80 % in mass of good-quality recycled materials. A batch of tests, both in the fresh and in the hardened state, are performed, covering on-site placement and long-term properties, to guarantee the suitability and the quality of the mixtures as structural concretes. Most of the results were encouraging, mainly depending on the aggregate and the binder types that were used. The freshstate workability of all the test mixtures was good. All the results in terms of hardened properties, strength (42 MPa in type I cement mixtures, and 32–38 MPa in type III cement mixtures), stiffness, long-term shrinkage, and microstructural state (porosity, permeability) were acceptable, their quality depending on the type of each component. The good results of the mixtures based on the slag-based binder deserve attention. Some weak points found were the slightly higher specific weight of the slag aggregate mixes (amounting to more than 2.7 Mg/m3 ), plastic shrinkage rates (in some cases greater than 1.2–1.5 thousand), and loss of resistance against chlorine penetration in recycled concrete mixes. However, drawbacks of that sort are no obstacle to their use in most structural applications.en
dc.description.sponsorshipThe authors wish to express their gratitude to the following entities for the funding they provided: MCIN/AEI/10.13039/501100011033 and ERDF A way of making Europe, the European Union, and Next Generation EU/PRTR [PID2020-113837RB-I00; PID2021–124203OB-I00 and TED2021-129715B-I00]; the Junta de Castilla y León (Regional Government) and ERDF [UIC-231]; the Basque Government [IT1619-22 SAREN Research Group]; the University of Burgos [Y135. GI].en
dc.language.isoenges
dc.publisherElsevieres
dc.relation.ispartofCase Studies in Construction Materials. 2023, V. 18, e02142es
dc.rightsAttribution-NonCommercial-NoDerivatives 4.0 Internacional*
dc.rights.urihttp://creativecommons.org/licenses/by-nc-nd/4.0/*
dc.subjectElectric arc furnace slagen
dc.subjectGround granulated black furnace slagen
dc.subjectLadle furnace slagen
dc.subjectQuarry tailingsen
dc.subjectRecycled concrete aggregateen
dc.subjectSustainable concreteen
dc.subjectFresh propertiesen
dc.subjectShrinkageen
dc.subjectWater penetrationen
dc.subjectChloride penetrationen
dc.subject.otherIngeniería civiles
dc.subject.otherCivil engineeringen
dc.subject.otherMateriales de construcciónes
dc.subject.otherBuilding materialsen
dc.titleFull-scale sustainable structural concrete containing high proportions of by-products and wasteen
dc.typeinfo:eu-repo/semantics/articlees
dc.rights.accessRightsinfo:eu-repo/semantics/openAccesses
dc.relation.publisherversionhttps://doi.org/10.1016/j.cscm.2023.e02142es
dc.identifier.doi10.1016/j.cscm.2023.e02142
dc.journal.titleCase Studies in Construction Materialsen
dc.volume.number18es
dc.type.hasVersioninfo:eu-repo/semantics/publishedVersiones


Fichier(s) constituant ce document

Thumbnail

Ce document figure dans la(les) collection(s) suivante(s)

Afficher la notice abrégée